Setup on Linux
This section describes the installation and licensing of FlowForce Server on Linux systems (Debian, Ubuntu, CentOS, RedHat).
System Requirements (Linux)
•Red Hat Enterprise Linux 7 or newer
•CentOS 7, CentOS Stream 8
•Debian 9 or newer
•Ubuntu 18.04, 20.04, 22.04
•AlmaLinux 9.0
•Rocky Linux 9.0
Prerequisites
•Perform installation either as root user or as a user with sudo privileges.
•The previous version of FlowForce Server must be uninstalled before a new one is installed.
•If you are installing FlowForce Server with other Altova server products, it is recommended that you install FlowForce Server first.
•The following libraries are required as a prerequisite to install and run the application. If the packages below are not already available on your Linux machine, run the command yum (or apt-get if applicable) to install them.
Required by | CentOS, RedHat | Debian | Ubuntu |
---|---|---|---|
FlowForce Server | libidn or libidn2, krb5-libs | libidn2-0, libgssapi-krb5-2 | libidn2-0, libgssapi-krb5-2 |
LicenseServer | libidn or libidn2, krb5-libs, fontconfig | libidn2-0, libgssapi-krb5-2, fontconfig | libidn2-0, libgssapi-krb5-2, libfontconfig |