Operators
To build FlowForce expressions, you can use the operators listed below. Remember that you can test any expression by calling the built-in function 
system/compute.
Operator | Description | Example |
|---|---|---|
== | Checks if a and b are equal (numerically equal for numbers, code-point equal for strings). | 2 + 3 == 5 computes to true
2 + 3 == 4 computes to false |
!= | Checks if a and b are not equal. Note that the following three expressions are equivalent:
•a != b •not (a == b) •a <> b | 2 + 2 != 5 computes to true
3 + 2 != 5 computes to false |
< | Checks if a is less than b (numerically less for numbers, see below for strings). | 4 < 5 computes to true |
<= | Checks if a is less than or equal to b. | 5 <= 5 computes to true |
> | Checks if a is greater than b. | 5 > 1 computes to true |
>= | Checks if a is greater than or equal to b. | 5 >= 5 computes to true |
+ | Addition. | 1 + 1 computes to 2 |
- | Subtraction. | 2 - 1 computes to 1 |
* | Multiplication. | 3 * 2 computes to 6 |
/ | Division. | 6 / 3 computes to 2 |
String comparisons are performed as follows:
•The common prefix of the two strings are ignored (evaluated on code points)
•If both remaining strings are non-empty, their first code points are compared numerically
•Empty strings are less than non-empty strings
Use parentheses to instruct FlowForce to evaluate the expression inside first. For example:
2 + 3 * 4 computes to 14.
(2 + 3) * 4 computes to 20.