Altova RaptorXML+XBRL Server 2025

This section describes the installation and licensing of RaptorXML+XBRL Server on Linux systems (Debian, Ubuntu, CentOS, RedHat). The setup comprises the following steps:

1.Install RaptorXML+XBRL Server

2.Install LicenseServer

3.Start LicenseServer

4.Register RaptorXML+XBRL Server with LicenseServer

5.Assign a license to RaptorXML+XBRL Server

The setup steps described above do not need to occur in exactly the same order in which they are listed. However, you do need to install before you start. And you do need to register RaptorXML+XBRL Server with LicenseServer before you can assign a license to RaptorXML+XBRL Server from LicenseServer.

System requirements (Linux)

•Red Hat Enterprise Linux 7 or newer

•CentOS 7, CentOS Stream 8

•Debian 10 or newer

•Ubuntu 20.04, 22.04, 24.04

•AlmaLinux 9.0

•Rocky Linux 9.0

Prerequisites

•Perform installation either as root user or as a user with sudo privileges.

•The previous version of RaptorXML+XBRL Server must be uninstalled before a new one is installed.

•If you plan to use Altova's Charts functionality, then at least one font must be installed on your system to ensure that charts will be rendered correctly. To list installed fonts, use, for example, the fc-list command of the Fontconfig library.

•The following libraries are required as a prerequisite to install and run the application. If the packages below are not already available on your Linux machine, run the yum command (or apt-get if applicable) to install them.